4. Connect
The camera can be connected via three connection methods: S.bus/TTL/ETH. Select the required connection method according to your needs.
Note: If you want the camera to output images normally, you must connect the network port.
After all cables are connected, power on the camera and wait for the camera to complete the self-check. (When you hear the ding-ding-ding sound, it means the camera has completed the self-check.)
4.1. Configure PC LAN IP address to the same IP segment as gimbal camera.
(Note:The last number of PC ip address should be different with the last number of camera IP address)
4.2.1. Enable video stream
Step 1. Input the Network video IP address: rtsp://192.168.2.119/554
Step 2. Click “Open Video” button to connect camera video.
4.2.1. If you use the ETH network port to connect
Step 1. Enter the IP address 192.168.2.119 and port 2000.
Step 2. Click the “Connect” botton to enable gimbal control.
4.2.3. If you use the TTL port to connect
Step 1. Chose the COM port and Baudrate 115200.
Step 2. Click the “Connect” botton to enable gimbal control.
Last updated
