LogoLogo
  • Introduction
  • VTOL Drone User Manual
    • Sky Whale VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Sky Whale Mini VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Sky Whale Max Eletric VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Sky Whale Max Hybrid VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection and preparation
        • 3.3. CoG calibration
        • 3.4 Connect UAV to ground station
        • 3.5. Warm up the engine:
        • 3.6. Calibration (operate when necessary)
        • 3.7. Preflight inspection
        • 3.8. Make a flight route
        • 3.9. Take Off
        • 3.10. In flight
        • 3.11. Landing
      • 4. Maintenance
      • 5. Engine Troubleshooting
      • 6.Engine Maintenance
    • Sky Fury VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • FW320 VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • FW250 VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Mapird Pro VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Mapird Plus VTOL
      • 1. Disclaimer and safety warning
      • 2. Specification
      • 3. Flight mission procedure
        • 3.1. UAV assembling
        • 3.2. Physical inspection
        • 3.3. CoG calibration
        • 3.4. Connect UAV to ground station
        • 3.5. Calibration (operate when necessary)
        • 3.6. Preflight inspection
        • 3.7. Make a flight route
        • 3.8. Take Off
        • 3.9. In flight
        • 3.10. Landing
      • 4. Maintenance
    • Avionics parts
  • Multirotor User Manual
    • YD4-1000S
      • Notice
      • 1. Product overview
      • 2. Install
      • 3. Connect drone to ground station
      • 4. Calibration (operate when necessary)
      • 5. Make a flight route
      • 6. Take Off
      • 7. In flight
      • 8. Landing
      • 9. Maintenance
    • YD6-1000S
      • Notice
      • 1. Product overview
      • 2. Install
      • 3. Connect drone to ground station
      • 4. Calibration (operate when necessary)
      • 5. Make a flight route
      • 6. Take Off
      • 7. In flight
      • 8. Landing
      • 9. Maintenance
    • YD6-1600S
      • Notice
      • 1. Product overview
      • 2. Install
      • 3. Connect drone to ground station
      • 4. Calibration (operate when necessary)
      • 5. Make a flight route
      • 6. Take Off
      • 7. In flight
      • 8. Landing
      • 9. Maintenance
    • YD6-1600L
      • Notice
      • 1. Product overview
      • 2. Install
      • 3. Connect drone to ground station
      • 4. Calibration (operate when necessary)
      • 5. Make a flight route
      • 6. Take Off
      • 7. In flight
      • 8. Landing
      • 9. Maintenance
    • YD6-1600M
      • Notice
      • 1. Product overview
      • 2. Install
      • 3. Connect drone to ground station
      • 4. Calibration (operate when necessary)
      • 5. Make a flight route
      • 6. Take Off
      • 7. In flight
      • 8. Landing
      • 9. Maintenance
    • YD6-1600L GAS ELECTRIC HYBRID HEXACOPTER
      • Disclaimer and safety warning
      • Specification
      • Installation
      • Add cooling liquid
      • Blending gasoline & Fuel the generator
      • About device power up and down
      • Generator ignition take off
      • Ground control software
      • Calibration
      • Mission Planning
      • Flight log reading
      • Peripheral device
      • Lipo battery charging & storage
  • Ground Station User Manual
    • LAUNCH GCS
      • 1. Disclaimer
      • 2. Software installation and Interface introduction
        • 2.1. Main interface
        • 2.2. Introduction to left column functions
        • 2.3. Introduction to top column functions
        • 2.4. Introduction to Right column functions
      • 3. How to plan a route
    • ROCK Ground Station
      • Disclaimer and safety warning
      • Specification
      • Left panel information and functions
      • Right panel information and functions
      • keyboard & Built-in antenna
      • 15.6-inch bright daylight monitor & 10-inch touch screen
  • Gimbal Camera User Manual
    • Optical Zoom Camera
      • Sky Eye 40HZ
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Sky Eye 30HZ-S
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Sky Eye U30
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Sky Eye HT50
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
    • EO/IR Zoom Camera
      • Storm Eye 40IE
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Storm Eye 30IE-HT
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Storm Eye 20IE-MK
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Storm Eye 30IE-M
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
      • Storm Eye 30IE-M50
        • Disclaimer and Warning
        • 1. Packing List
        • 2. Gimbal description
        • 3. Install
        • 4. Connect
        • 5. Parameter information
    • Gimbal Setting Guidance
      • S.Bus Setting
      • Video Output Frame Setting
    • YDlink Control software
      • 1.Download & Connect
      • 2. Control and configuration
      • 3. Settings window
      • 4. Card file
      • 5. Help
  • Video & data Link User Manual
    • Videopass-N15
      • 1. About N15
      • 2. Precautions & Setup Information
      • 3. Network segment setting
      • 4. How to connect the camera
      • 5. How to connect the drone
    • Videopass-N30
      • 1. About N30
      • 2. Precautions & Setup Information
      • 3. Network segment setting
      • 4. How to connect the camera
      • 5. How to connect the drone
    • Videopass-N60
      • 1. About N60
      • 2. Precautions & Setup Information
      • 3. Network segment setting
      • 4. How to connect the camera
      • 5. How to connect the drone
    • Videopass-N150
      • 1. About N150
      • 2. Precautions & Setup Information
      • 3. Network segment setting
      • 4. How to connect the camera
      • 5. How to connect the drone
    • SHADOW AAT
      • Specification
      • How to connect cables
      • How to set up the connection
Powered by GitBook
On this page
  • 2.1. Specification
  • 2.2. Size
  1. VTOL Drone User Manual
  2. Sky Whale Max Eletric VTOL

2. Specification

Previous1. Disclaimer and safety warningNext3. Flight mission procedure

Last updated 8 days ago

2.1. Specification

2.2. Size