3. Network segment setting

In order to connect N100 to ground station computer, please open the network settings on computer and add configure IP address with same network segments with N100.

Step 1: Add IP address:172.16.172.xx (xx can be any number from 2 to 253 expect 20) and IP address: 192.168.147.xx(xx can be any number from 2 to 253, expect 10 and 20) network. This network segment is used to connect flight control and data communication.

Step 2： Configure PC LAN IP address to the same IP segment as gimbal camera

(Note:The last number of PC ip address should be different with the last number of camera IP address)

Eg:

• Default camera IP address is: 192 . 168 . 2 . 119

• PC IP address: 192 . 168 . 2 . 3 (only the last number should be different than 119.)

• Subnet mask: 255 . 255 . 255 . 0

• Default gateway: 192 . 168 . 2 . 1