Mission Planning

1. Pre-check before drawing the mission route

1.1 Make sure the lipo battery is full charged. The full voltage is 52.2V. It displayed on HUD
1.2 Make sure the calibration of accelerometer/compass/airpeed have done.
1.3 Make sure the orientation of the drone's head is correct.
1.4 Make sure the isn't an error/warning message on HUD
1.5 Make sure the Hdop<1, and Sats>15.
1.6 Make sure there is no more than 20m building within a 100m radius, no metal around the VTOL.
1.7 Make sure the drone's head is anti the wind.
1.8 Make sure the servos will react when pushing the knob of the RC controller.
1.9 Make sure the battery of the video transmitter/RC controller is enough.
1.10 Make sure all parts have been installed firmly, including propeller, arms, ailerons, tail, landing gear, antenna, and all buttons.
1.11 Strongly recommend 2 pilots to conduct the mission: one pilot controls the drone through an RC controller while the other pilot takes care of the data from ground control software.

2. Draw the mission route

2.1 After the connection is successful, click to select the waypoints that need to be executed.
2.2 Click the “Auto route” button and confirm “Yes”, the software will automatically generate take-off and landing waypoints.
2.3 Check that the waypoint area is correct, click the (1) “Write route” button to write the route, confirm “Yes”, and the regular route planning is completed.

3. Auto flight

3.1 Check HERE to watch the video tutorial.
3.2 Put the RC throttle at the low position and switch to QHOVER mode (SC gear at low position).
3.3 Go to the “Flying” interface, click (1) “Auto” to make the aircraft enter the automatic mode, and then click (2) “ARM / Disarm” to unlock, the aircraft will automatically take off to perform the mission and return home automatically.
Attention: Please DO NOT flip the mode gear (SC gear) of the RC during the auto flight unless you want to control the drone manually.
How to land the drone manually: for example, flip the SC gear from the low position to the middle position, and then back to the low position again to enter the flight mode QHover. You can land the drone manually under this mode.

4. Mapping route setting

Copy link
On this page
1. Pre-check before drawing the mission route
2. Draw the mission route
3. Auto flight
4. Mapping route setting