Search
K
Comment on page

Connect & control

1. How to open video stream

Confirm that the power supply and signal cables of the gimbal camera are connected. The run YDlink, Click “Connect” interface
  • Step 1. Input the gimbal'default IP address: rtsp://192.168.2.119/554
  • Step 2. “Open Video” then image appears.

2. Control the gimbal by TCP

2.1 Power on the gimbal by DC12V-26V(4S-6S). and Connect it to Air unit ETH1 or ETH 2.(Use the N30 videopass as an example)
2.2 Open the "Connect" interface, Enter the TCP IP address "192.168.2.119" and Port "2000", Click the "Connect" to start control.

3. Control the gimbal by TTL

3.1 Power on the gimbal by DC12V-26V(4S-6S). and Connect it to Air unit TTL2 or TTL1.(Use the N30 videopass as an example)
3.2 Open the "Connect" interface, Select the "Serial port " and baud rate "115200", then "connect".