Installation

1. Aircraft fuselage installation

1.1 Landing gear installation: install the left and right brace (01), absorb sleeve (02), and screw down the opening (03).

1.2 Fix the mounting carbon board under the fuselage(as shown in the picture below).

(The carbon plate is used for the mounting payload. Support customization)

1.3 Align the assembled bracket (as shown in 01) with the hole position (as shown in 01-1), fix it on the carbon plate (as shown in 02) below the fuselage, and install & tighten the four screws.

1. If you have a KUA payload box, it can be installed together with the mounting bracket.

2. To avoid the inconvenience of calibration due to the heavy weight of the whole machine after installation, the aircraft can be powered on and calibrated before the arms are assembled.

KUA PAYLOAD DROP SYSTEM FOR MULTI-ROTORS

1.4 Install the 6 arms following the indicated number and tighten the propeller with a screwdriver, as shown in the figure below.

2. Battery installation

2.1 Connect the 4 unit 25000mAh batteries by series.

2.2 After the power-on is completed, fix it firmly with a cable tie, put the cover on the fuselage, and tighten the cover with four nuts.